Advertisement
NOTE:
NOTE:
6
Procedure
Procedure
If you need to update your Model 744 board computer's firmware or
operating system as instructed in Prerequisites, update now before
completing the procedure.
If you are installing four PMC cards onto a Model 744 that has onboard
graphics, you will need to disable the onboard graphics (directions are later
in the procedure). You will also need to redirect the console path before
shutting off the system:
i
Reboot the system.
ii If Autoboot is turned on, press any key when you see the following mes-
sage:
Processor is starting Autoboot process. To discontinue,
press any key within 10 seconds.
iii Use the following command at the Main Menu prompt to configure the
console path for a PMC graphics card:
pa con pmc n
where n is the PMC card site number.
Advertisement
