Siemens SINUMERIK 840D sl Series Diagnostics Manual page 124
Hide thumbs
Also See for SINUMERIK 840D sl Series:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Overview of Alarms
Reactions:
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy:
• Modify part program
• Install "Orientation transformation" option
Program Con-
Clear alarm with NC START or RESET key and continue the program.
tinuation:
10784
Channel %1 block %2 illegal tool for tool radius compensation with constraint sur-
face
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
When activating the tool radius compensation with constraint surface, an illegal tool type
is active.
Only cutting tools of the tool types 1 to 399 are admitted with the following exceptions:
• 111 ball end milling cutter
• 155 torus milling cutter
• 156 torus milling cutter
• 157 torus milling cutter
Reactions:
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy:
Use another tool.
Program Con-
Clear alarm with NC START or RESET key and continue the program.
tinuation:
10790
Channel %1 block %2 plane change during linear programming with angles
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The active plane was changed between the first and second subblock when programming
two straight lines with angle parameters.
Reactions:
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy:
Modify part program.
Program Con-
Clear alarm with NC START or RESET key and continue the program.
tinuation:
10791
Channel %1 block %2 invalid angle during linear programming
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
No intermediate point was found when programming a contour consisting of two straight
lines and an angle specification.
Reactions:
- Correction block is reorganized.
2-124
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005
Hide quick links:
Advertisement
Chapters
Table of Contents
