Table of Contents
Advertisement
BODY AND TRIM
DASH INSTALLATION
1. Pass the steering wheel through the instrument panel hole in the dash.
2. Attach the dash clips along the bottom edge of the dash onto the frame above the floor matt.
3. Install the instrument panel:
3.1. Attach electrical components to connections on the back of the instrument panel
3.2. Position the instrument panel onto the dash and push plastic fasteners into place.
4. Install front body. See Front Body Installation on page 4-5.
FRONT BODY INSTALLATION
1. Position front body onto frame and attach head lights to wire harness at spade connectors.
2. Install body (9) under body covers (12) and (13), and align holes with dash and body support (Figure 4-3,
Page 4-5).
3. Install body and dash screws and scalloped washers on the top of the body. Tighten to 45 in-lb (5 N·m).
4. Attach plastic caps (5) onto dash screws.
5. Install plastic screws on the sides of the dash and body.
6. Install bumper or brush guard. See Bumper Installation or Brush Guard Installation Page 4-4.
TYPICAL
5 PLACES
2005-2006 HUV4210-G, 4210-E, 4210-GXP, 4210-EXP Maintenance and Service Manual
TYPICAL
TYPICAL
3 PLACES
2 PLACES
16
17
Figure 4-3 Front Body Assembly
TYPICAL
3 PLACES
TYPICAL
2 PLACES
1
4
Front Body
Page 4-5
Advertisement
Table of Contents
