Table of Contents
Advertisement
Making Adjustments
Adjusting the Height and Tilt
The difference in height between the finisher and the upstream connection machine and the tilt of the finisher and the upstream connection machine need to be adjusted depending on the installation
site floor condition. If the height or tilt are not adjusted properly, problems can occur (for example, a paper jam can occur frequently at the paper supply section of the finisher). Check the height and
tilt and adjust it as required.
■
Checking the Difference in Height and the Tilt
1) Check the difference in height between the finisher and the upstream connection machine. Make sure that the difference in height between the top surface of
the finisher and the top surface of the upstream connection machine is within 0±2mm.
Measure the difference in height at two points (at the front and rear), and then check that the difference in height between the front and rear is within 1.5mm.
Scale
The height difference must be
within 1.5mm.
6
Installation > Making Adjustments > Adjusting the Height and Tilt > Checking the Difference in Height and the Tilt
0±2mm
0±2mm
6
Installation > Making Adjustments > Adjusting the Height and Tilt > Checking the Difference in Height and the Tilt
F-6-80
F-6-80
6-30
6-30
- Quick Links:
- List of Parts
- List of Motors
- List of Sensors
Hide quick links:
Advertisement
Table of Contents
