Specifications
8
Technical data
8 Specifications
8.1 Technical data
Detector line
Line separator
External alarm indicators
Connections
28 | 32
You will find information on approvals, CE marking, and the relevant EU directives
for this device (these devices) in the following document(s); see 'Applicable
documents' chapter:
●
Document 007065
Operating voltage
Operating current (quiescent)
Maximum current connection factor
Quiescent current connection factor
Address connection factor
Separator connector factor
Protocol
Compatibility
Line voltage:
●
Nominal
●
Minimum
●
Maximum
Voltage at which the line separator opens:
●
Minimum
●
Maximum
Permanent current when switches are
closed
Switching current (e.g., in the event of a
short-circuit)
Leakage current when switches are open
Serial impedance when switches are
closed
When operated on the FDnet/C-NET, the line separator is closed via an actuation
signal from the control panel. Required line voltage: DC 12...33 V (normal range)
Number of external alarm indicators that
can be connected
Detector line:
●
Design
●
Cable cross section
DC 12...33 V
250 µA
1
1
1
1
FDnet/C-NET
See 'List of compatibility'
DC 32 V (= V
)
nom
DC 12 V (= V
)
min
DC 33 V (= V
)
max
DC 7.5 V (= V
)
SO min
DC 10.5 V (= V
)
SO max
Max. 1.5 A (= I
)
C max
Max. 2 A (= I
)
S max
Max. 1 mA (= I
)
L max
Max. 0.4 Ω (= Z
)
C max
None
Strands 500 mm long with pressed-
on 2.8 x 0.8 mm flat connector
sleeves
0.5 mm
2
007063_h_en_--