Table of Contents
Advertisement
1. Steering shaft upper joint bolt
2. Steering shaft lower joint bolt
[1.3 L and 1.6 L engine models
(2WD Vehicle)]
1. Engine rear mounting
2. Mounting bracket
REMOVAL
1) Take out fluid in P/S fluid reservoir with syringe or such.
2) After removing joint covers, loosen steering shaft upper joint
bolt (but it must not be removed) and remove lower joint bolt.
3) With front wheels in straight-ahead position, separate pinion
and lower joint.
4) Hoist vehicle and remove both right and left front wheels.
5) Remove split pin and then remove tie rod castle nut from steering
knuckle.
1. Steering knuckle
2. Castle nut
3. Split pin
6) Using special tool, remove tie rod end from knuckle.
Special Tool
(A): 09913-65210
1. Knuckle
2. Tie rod end
7) [1.3 L and 1.6 L engine models]
For 2WD M/T vehicle, disconnect gear shift control shaft and
extension rod from transmission.
For 2WD vehicle, remove engine rear mounting together with
its bracket from engine and member, and remove engine
mounting member.
For 4WD vehicle, remove exhaust pipe No.2, engine rear
torque bush and bracket, disconnect suspension arm (right
side) from knuckle and then right side drive shaft joint from cen-
3. Mounting member
4. Suspension frame
ter bearing support.
CAUTION:
Be sure to set front wheels (tires) in straight direction
and remove ignition key from key cylinder before the
following steps, otherwise contact coil of airbag sys-
tem may get damaged.
POWER STEERING (P/S) SYSTEM 3B1-19
- Quick Links:
- How to Use this Manual
- Wiring Diagram
Hide quick links:
Advertisement
Chapters
Table of Contents
