Call Forwarding Within A Call Group (Cg) - Siemens HiPath 1100 Programming Manual
Analog mf telephones
Hide thumbs
Also See for HiPath 1100:
- Service manual (389 pages) ,
- Programming manual (241 pages) ,
- User manual (137 pages)
Table of Contents
Advertisement
Step by Step
*
Deleting Extensions from a Call Group (CG)
Required: Programming Mode must be active (*95
31994).
1 1 3
Enter the code for programming.
Enter the Call Group number (770 to 779).
All extensions belonging to the Call Group selected are
*
deleted.
#
Press this key.
Initial state for Programming Mode.
Call Forwarding within a Call Group (CG)
This feature works only on digital lines. It provides Call
Forwarding for extensions belonging to Call Groups.
When a call is routed to a Call Group, it rings at all exten-
sions at the same time. The extension configured for
Call Forwarding will ring at its destination. If the call is
answered, the other extensions in the group stop
ringing. Otherwise, the call rings again until one of them
answers it.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
2 2 2
or
Activate/Deactivate Call Forwarding:
#
= To activate
*
#
= To deactivate (default)
Press this key.
Initial state for Programming Mode.
An extension may be configured for more than
one Call Group (CG).
When the ""Call Deflection" on page 144" feature
(Code 228) is activated, external Call Forwarding
to an extension that is a member of a group can-
not be used (it does not work on analog lines).
In this case the system does not receive any in-
formation about the forwarded call having been
answered or not. Since the system does not
have this information, it continues to signal all
other group members.
Programming an Extension
55
- Quick Links:
- Programming Mode
Hide quick links:
Advertisement
Table of Contents
