Step by Step
Call Charges
Call Charge Unit
To show call charges in currency units you must specify
a call charge factor. Pulses are multiplied by this factor.
A Call Charge unit consists of a pulse sent over a line by
a public exchange to provide and display call charge in-
formation according to the type of call (local, DDD, Inter-
national, etc.) and other criteria determined by the car-
rier.
The default value is the "0" comma slot and the "00001"
factor.
Required: Programming Mode must be active (*95
31994).
1 9 5
Enter the code for programming.
Set the Call Charge Factor (9 digits).
Enter the decimal separator position (0 to 3)
Examples:
– for US$ 0.12: 000000012 and 2 (comma position)
– for US$ 2.00: 00002 and 0 (comma position)
– For example, for US$ 123456.789: 123456789
Initial state for Programming Mode.
On HiPath 1100 systems the Billing facility (Call
Cost Limit by Extension) is only available for
digital trunks (ISDN and CAS). Please consult
your local carrier to know if this service is provid-
ed.
and 3 (comma position)
General Programming
101