Adsl Module; Restoring The Adsl Module Default Settings - Siemens HiPath 1100 Programming Manual
Analog mf telephones
Hide thumbs
Also See for HiPath 1100:
- Service manual (389 pages) ,
- Programming manual (241 pages) ,
- User manual (137 pages)
Table of Contents
Advertisement
ADSL Module
Step by Step
154
ADSL Module
The ADSL module allows you to connect PCs to a net-
work and have them share the ADSL access without re-
quiring a splitter, ADSL modem, hub or any additional
network cards. To share access simply install the mod-
ule in one of the PCs.
The PCs are connected to the HiPath 1100, which pro-
vides the same functions as the V.24 serial interface via
LAN. This capability is used for integrating applications
such as the HiPath 1100 Manager, Interaction Center
Smart and CDR applications. ADSL access must be en-
abled by a carrier for one of the lines. An Internet pro-
vider is also required.
To configure the ADSL module correctly you need infor-
mation about the ADSL protocol, the carrier's VPI/VCI,
the provider's DNS servers, user name and password.
This information is entered in the HiPath 1100 ADSL
Manager Administrative software for configuring the
module correctly.
All the PCs must have a network card installed and be
on the same network as the ADSL module used as a
gateway for accessing the Internet (the default IP is
10.0.0.1). For example, a network with IP addresses
from 10.0.0.2 to 10.0.0.10 and subnet mask
255.255.255.0.
Restoring the ADSL Module Default
Settings
This code restores the default configuration of the
ADSL module assuming an IP of 10.0.0.1.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0
1 3
Initial state for Programming Mode.
Do not connect a V.24 interface adapter cable to
the switch when using an ADSL module. All data
is delivered through the network. Remember to
configure the Communications Server for the
network connection.
- Quick Links:
- Programming Mode
Hide quick links:
Advertisement
Table of Contents
