Table of Contents
Advertisement
(num)
<type>
Type of address octet, which defines the used type of number (ton) and the numbering plan identification (npi).
Please consider that for types other than 129 or 145 dialing from phonebook with
on the network, not always possible (refer to GSM 04.08 subclause 10.5.4.7 for details). See also
AT+CPBW.
Possible values are:
145
161
209
255
129
(str)(+CSCS)
<text>
Text assigned to a phone number. The maximum length for this parameter is given with test command response
parameter <tlength>.
If using an ASCII terminal characters which are coded differently in ASCII and GSM have to be entered via
escape sequences as described in Section 1.5,
(num)
<maxloc>
Maximum location number for the currently selected storage. For phonebooks located on the SIM this value
depends on the SIM card type.
(num)
<nlength>
Maximum length of phone number for "normal" locations. Depending on the storage a limited number of loca-
tions with extended memory is available per phonebook. These locations allow storing numbers with twice the
standard length, which is
saved with <type>=209.
(num)
<tlength>
Maximum length of
<text>
given in octets. If
<text>
string is given in UCS2, the maximum number of characters depends on the coding scheme used for the alpha
field of the SIM according to GSM 11.11, Annex B [21]. In the worst case the number of UCS2 characters is at
least one less than half the number of GSM characters.
Note
•
Users should be aware that when using this AT command quickly after SIM PIN authentication the SIM data
may not yet be accessible, resulting in a short delay before the requested AT command response is returned.
See Section 20.1,
Restricted access to SIM data after SIM PIN authentication
MC55_ATC_V04.00
Confidential / Released
Dialing string
<number>
National number. Network support of this type is optional.
Dialing string
<number>
digit characters other than "*", "#" or "+". Note that phonebook entries saved
with this type cannot be dialed.
Dialing string
<number>
i.e. "*", "#" codes are contained. Network support of this type is optional.
Otherwise
Supported character
2*<nlength>
digits for normal numbers, but only
assigned to the telephone number. The value indicated by the test command is
is given as GSM characters each character corresponds to one octet. If the
Page 383 of 475
ATD><mem><n>
includes international access code character '+'
has been saved as ASCII string and includes non-
is a command to control a Supplementary Service,
sets.
<nlength>
for further detail.
is, depending
of
<type>
digits for numbers
<text>
3/17/06
Advertisement
Table of Contents
