Table of Contents
Advertisement
11.3
AT+CGATT GPRS attach or detach
Syntax
Test Command
AT+CGATT=?
Response(s)
+CGATT: (list of supported <state>s)
OK
Read Command
AT+CGATT?
Response(s)
+CGATT:
<state>
OK
Write Command
AT+CGATT=[<state>]
Response(s)
OK
ERROR
+CME ERROR
Reference(s)
GSM 07.07
Command Description
The test command is used for requesting information on the supported GPRS service states.
The read command returns the current GPRS service state.
The write command is used to attach the MT to, or detach the MT from the GPRS service. After the command
has completed, the MT remains in V.250 command state. If the MT is already in the requested state, the com-
mand is ignored and the OK response is returned. Any active PDP contexts will be automatically deactivated
when the attachment state changes to detached.
If the MT is not able to attach for more than 5 minutes, command returns "ERROR" or "+CME ERROR:
unknown", but MT is still trying to attach.
If the MT is not able to detach for more than 1 minute, command returns "ERROR" or "+CME ERROR: unknown",
but MT is still trying to detach. If an attach is issued during a running detach, command returns "ERROR" or
"+CME ERROR: unspecified GPRS error".
Parameter Description
(num)
<state>
Indicates the state of GPRS attachement.
(P)
0
[1]
Notes
•
If the MT is in dedicated mode, write command returns "+CME ERROR: operation temporary not allowed".
•
When the module is GPRS attached and a PLMN reselection occurs to a non-GPRS network or to a network
where the SIM is not subscribed to for using GPRS, the resulting GMM (GPRS mobility management) state
according to GSM 24.008 is REGISTERED/NO CELL, meaning that the read command will still show
<state>=1.
MC55_ATC_V04.00
Confidential / Released
PIN
%
detached
attached
Page 270 of 475
ASC0 ASC1
MUX1
MUX2
%
%
%
%
MUX3 Charge
Last
%
!
!
!
3/17/06
Advertisement
Table of Contents
