■Interrupt pointer setting
In CW Configurator, the setting for interrupt pointer is changed as follows.
• Setting the SI No. for an interrupt module is not required.
• "Interrupt pointer" of an interrupt module must be sequential numbers. (Set I51 to No.2 and I52 to No.3 when No.1 is set to
I50, for example.)
Setting/monitoring tools for the C Controller module
[Navigation window] [Parameter] [CCPU
Parameter] [System settings] tab [Intelligent
Function Module Setting] [Interrupt event settings]
button
Intelligent function module tool
"Intelligent Function Module Tool" is changed to the window shown below.
Setting/monitoring tools for the C Controller module
[Tool] [Intelligent Function Module Tool] [(tool for
each module)]
APPX
104
Appendix 2 How to Use MELSEC-Q Series Modules
CW Configurator
[Navigation window] [Parameter] [Module
Information] [(module name)] [Module Parameter]
CW Configurator
[Tool] [Module Tool List] [Q Series] [(tool for
each module)]