Solenoid-B, Valves; Solenoid And Pressure Control Solenoid Removal And Installation - Suzuki Grand Vitara Manual
Transmission / transaxle
Hide thumbs
Also See for Grand Vitara:
- Owner's manual (1736 pages) ,
- Service manual (836 pages) ,
- Supplementary service manual (481 pages)
Table of Contents
Advertisement
Installation
When replacing them, be sure to note the followings.
• To replace clamps at the same time
• To insert hose as far as its limit mark
• To clamp hose securely
1) Use new union gaskets and connect oil cooler pipes
to oil outlet unions.
2) Connect hoses to pipes and clamp them securely.
3) Tighten union bolts to specified torque with oil outlet
union locked referring to "Oil Cooler Hose and Pipe
Components: ".
4) Tighten pipe bolt to specified torque referring to "Oil
Cooler Hose and Pipe Components: ".
5) Check A/T fluid level according to procedure
described in "A/T Fluid Level Check: ". Add if
necessary.
6) Check for fluid leakage after warming up A/T.
Solenoid Valves (Shift Solenoid-A, Shift
Solenoid-B, TCC Pressure Control Solenoid and
Pressure Control Solenoid Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Pull out fluid level gauge and lift up vehicle.
3) Remove drain plug (3) and drain A/T fluid.
4) Install drain plug (3) with new gasket.
5) Remove oil filler tube (2) and A/T oil pan (1).
3
www.CarGarage.ir
S5JB0A5106060
2
1
I5JB0A510051-02
www.CarGarage.ir
Automatic Transmission/Transaxle:
6) Remove A/T oil strainer (1).
1
7) Disconnect shift solenoid–A connector (1), shift
solenoid–B connector (2), TCC pressure control
solenoid connector (4) and Pressure control solenoid
connector (3).
8) Remove solenoid valves.
3
4
Installation
Remove removal procedure to install solenoid valves,
noting the following points.
• For details of solenoid valves and their connectors
installation, refer to "Automatic Transmission Unit
Assembly: ". Use new O-ring.
• For details of A/T oil pan installation, refer to
"Automatic Transmission Unit Assembly: ".
• Tighten exhaust No.1 pipe bolts & nuts and exhaust
bracket bolts & nuts.
• Fill A/T fluid and check fluid level according to
procedure described in "A/T Fluid Change: ".
• Check for fluid leakage after warming up A/T.
5A-91
I5JB0A510052-01
1
2
I5JB0A510053-01
Advertisement
Table of Contents
