Repair Instructions; Clutch Pedal Position (Cpp) Switch Removal And Installation; Clutch Pedal Position (Cpp) Switch Inspection And Adjustment; Clutch Fluid Pipe And Hose Removal And Installation - Suzuki Grand Vitara Manual
Transmission / transaxle
Hide thumbs
Also See for Grand Vitara:
- Owner's manual (1736 pages) ,
- Service manual (836 pages) ,
- Supplementary service manual (481 pages)
Table of Contents
Advertisement
5C-4 Clutch:
Clutch Pedal Position (CPP) Switch Removal
and Installation
Removal
1) Disconnect connector of CPP switch (1) with ignition
switch OFF.
2) Remove CPP switch (1) from pedal bracket.
Installation
1) Instal CPP switch to pedal bracket.
2) Adjust switch position referring to "Clutch Pedal
Position (CPP) Switch Inspection and Adjustment: ".
3) Connect connector to CPP switch securely.
Clutch Pedal Position (CPP) Switch Inspection
and Adjustment
Inspection
Check for resistance between terminals under each
condition below. If check result is not satisfactory,
replace.
CPP switch resistance
When switch shaft is pushed (1): Continuity
When switch shaft is free (2): No continuity
www.CarGarage.ir
Repair Instructions
Adjustment
With clutch pedal (1) released, adjust switch (2) position
so that clearance between end of thread and clutch
S5JB0A5306001
pedal arm is within specification.
Clearance between end of thread and clutch pedal
arm
"a": 0.5 – 1.5 mm (0.02 – 0.06 in.)
I5JB0A530005-02
Clutch Fluid Pipe and Hose Removal and
Installation
CAUTION
!
Do not allow fluid to get on painted surface. It
may cause painted surface damage.
Removal
1) Remove dust and dirt from each joint of hose and
pipe to be disconnected and clean around reservoir
S5JB0A5306002
cap of brake master cylinder.
2) Take out fluid with syringe or such.
3) Remove clamp (1) of clutch master cylinder (2) and
disconnect fluid pipe (3).
I5JB0A530006-01
www.CarGarage.ir
3
1
2
1
3
2
"a"
1
I5JB0A530007-02
S5JB0A5306003
I5JB0A530008-01
Advertisement
Table of Contents
