Qos-Policy-Output - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Usage Information To specify the name of the input QoS policy, use this command. After the input policy

is specified, rate-police is defined. This command enables Qos-Policy-Input

Configuration mode — (conf-qos-policy-in).

When changing a Service-Queue configuration in a QoS policy map, all QoS rules are

deleted and re-added automatically to ensure that the order of the rules is maintained.

As a result, the Matched Packets value shown in the show qos statistics

command is reset.

If you create create a QoS input policy to be used for CoPP, you must enter the

keyword cpu-qos.

Use this command in Configuration Terminal Batch mode to create the QoS input

policy in a dual-homing setup.

qos-policy-output

Create a QoS output policy.

C9000 Series

qos-policy-output qos-policy-name

To remove an existing output QoS policy, use the no qos-policy-output qos-

policy-name command.

qos-policy-name

Command Modes

CONFIGURATION

CONFIGURATION TERMINAL BATCH

Command History

This guide is platform-specific. For command information about other platforms, refer

to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

— incoming traffic policing function.

Enter your output QoS policy name in character format (32

characters maximum).

Introduced the Configuration Terminal Batch mode on C9010.

Introduced on the C9010.

Quality of Service (QoS)

Table of Contents