Table of Contents
Advertisement
22
Installation
F
2
G
H
Battery communication connection
Connect the supplied BMS cable to the battery and connect the other end of the BMS cable to the product as
igure below. After making a connection, fasten the screws on the connector to ix it.
Insert each wire-end to the corresponding
ferrule-hole in the Battery DC terminals and
tighten the cable tie securely.
(–)
Black wire
Red wire
(+)
CAUTION
Incorrect battery polarity will damage the
product. This damage is not covered by the
warranty.
Fasten the cap of cable gland to ix the cable.
Assemble the lower cover to the product.
And then ix the screws in numbering order.
Battery
Battery DC
Terminals
Advertisement
Table of Contents
