Table of Contents
Advertisement
Programming Manual for Digital Key Telephone System
300 & LDK-100
instead of speech Setup message.
2. If a busy extension, which is assigned to
data line security, receives an incoming CO
call, the call is disconnected with cause busy
regardless of the DID/DISA Destination
setting.
DELAYED CO LINE RING
Description
The ring signal can be sent to the assigned
station(s) immediately upon detection or can be
sent after an assigned delay (number of ring
cycles: 0~9). The delay can be assigned based on
station.
Admin Programming
n
CO Line Ring Assignment (PGM 144)
Condition
1. When the delay ring counter is assigned to 0,
the ring signal can be sent to the assigned
station immediately when it is detected.
2. The delay ring is not applied when CO line
ring is assigned to a station group.
3. Private lines may be assigned with delayed
ring.
4. Delayed CO line ring will not be supported in
Weekend/On-demand mode
DIAL BY NAME
Description
The system will allow station users to dial
extension numbers by entering a name that has
been programmed for the station (intercom). Also
each station may be assigned with a name up to 7
characters and speed dial (system and station)
number may be assigned with a name of up to 16
characters. When the names are programmed in
the digital display keyset, the user may select a
station or speed dial number by the name. The
user selects from one of three directories
(intercom, user speed dial or system speed dial)
and enters alpha-numeric data with 2 dial pad
keystrokes per character. The s ystem finds and
displays the first matched name based on the
characters entered. The user may at any point
scroll using [? ]/[? ] buttons through the names in
the directory and select a name to call. If user
wants to display the matched phone number to
the selected name, press [FLASH] button.
Operation
To access Dial by Name,
1. Press the [SPEED] button twice.
2. Dial the desired directory (1, 2, or 3) and
confirmation tone is heard.
1 = Intercom / 2 = Station Speed Dial /
3 = System Speed Dial
3. The stored names in the speed bin are
displayed in alphabetical order.
To search a name by entering a character,
1.
While two names are displayed on the LCD,
enter alpha-numeric data with 2 -dial keypad
strokes per the character.
2.
The LCD displays 2 names which are
started with the entered character. (The
cursor points to the first name in the LCD.)
3.
Entering another alpha-numeric data, then
LCD will display names started with the
updated input. It will be continued until you
stops entering the character.
4.
When the matched name is displayed, move
the cursor to the name (The cursor points to
the first name in the LCD.) and press
[HOLD/SAVE] button to make a call.
To search a name by scrolling,
1.
While two names are displayed on the LCD,
2.
Press the [? ] key with the cursor on the first
line and the cursor points to the second line
on the LCD.
3.
Press the [? ] key with the cursor on the
second line, then the cursor points to the
first line on the LCD.
4.
Press the [? ] key with the cursor on the
second line, the next two lists are displayed
on the LCD.
5.
When the matched name is displayed, move
the cursor and press the [HOLD/SAVE]
button to make a call.
3-9
LDK-
System Features
Advertisement
Table of Contents
