Basic Stage Cooling; Basic Stage Cooling - Status Object Cooling; Basic Stage Cooling - Mode Of The Control Value; Basic Stage Heating - Control Value Difference For Sending Of Heating Control Value - ABB i-bus KNX Product Manual
Room temperature controller
Hide thumbs
Also See for i-bus KNX:
- Product manual (264 pages) ,
- Product manual (240 pages) ,
- Product manual (45 pages)
Table of Contents
Advertisement
11.5.48 Basic stage cooling
Note
Only available when the "Extended settings" parameter under "Cooling control"
is set on "Yes".
11.5.49 Basic stage cooling — Status object cooling
Options:
This parameter enables the "Status cooling" communication object.
11.5.50 Basic stage cooling — Mode of the control value
Options:
The mode of the control value can be used to adapt the control value to de-energised opened
(normal) or de-energised closed (inverse) valves.
–
N ormal : Value 0 means "Valve closed".
–
Inverse : Value 0 means "Valve open".
11.5.51 Basic stage heating - Control value difference for sending of heating control value
Options:
The control values of the 0 - 100% PI continuous controller are not transmitted after every
calculation. Instead, they are transmitted when the calculation results in a value that is different
enough to the previous sent value to make a transmission meaningful. This value difference
can be entered here.
Note
This parameter is only available when "Control value type" parameter is set
either on "PI continuous, 0 – 100%,"PI PWM, On/Off" or "Fan coil".
Product manual 2CKA001473B9482
Description of application and parameters
No
Yes
Normal
Inverse
2%
5%
10%
Send cyclic only
Application "Function block RTC"
│95
Advertisement
Table of Contents
