Igmp-Snooping Leave Source-Ip - HP 3600 v2 Series Command Reference Manual
Ip multicast
Hide thumbs
Also See for 3600 v2 Series:
- Command reference manual (510 pages) ,
- Configuration manual (449 pages) ,
- Security configuration manual (398 pages)
Table of Contents
Advertisement
Default level
2: System level
Parameters
interval: Specifies the IGMP last-member query interval in seconds. The value ranges from 1 to 5.
Description
Use igmp-snooping last-member-query-interval to set the IGMP last-member query interval in the VLAN.
Use undo igmp-snooping last-member-query-interval to restore the default.
By default, the IGMP last-member query interval is 1 second.
The IGMP last-member query interval determines the interval for sending IGMP group-specific queries
and the maximum response delay for IGMP group-specific queries in a VLAN.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: igmp-snooping enable and last-member-query-interval.
Examples
# Enable IGMP snooping and set the IGMP last-member query interval to 3 seconds in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping last-member-query-interval 3
igmp-snooping leave source-ip
Syntax
igmp-snooping leave source-ip { ip-address | current-interface }
undo igmp-snooping leave source-ip
View
VLAN view
Default level
2: System level
Parameters
ip-address: Specifies a source address for the IGMP leave messages that the IGMP snooping proxy sends,
which can be any legal IP address.
current-interface: Specifies the IP address of the current VLAN interface as the source address of IGMP
leave messages that the IGMP snooping proxy sends. If no IP address has been assigned to the current
VLAN interface, the default IP address 0.0.0.0 is used.
Description
Use igmp-snooping leave source-ip to configure the source IP address of the IGMP leave messages that
the IGMP snooping proxy sends.
Use undo igmp-snooping leave source-ip to restore the default.
21
Advertisement
Table of Contents
