Select "Phone Book" or "Dial" depending on the registration status of the next
remote party.
Select "Phone Book", then perform steps 2 and 3 of the procedure shown in
"To call a remote party registered in the Phone Book" on page 206, or select
"Dial", then perform steps 2 to 4 of the procedure in "To call a remote party
not registered in the Phone Book" on page 206.
Repeat this procedure for each remote party.
Receiving a Call from a Remote Party
Operations are the same as those for a point-to-point conference.
For details, see "Receiving a Call from a Remote Party" on page 91.
Ending a Videoconference
To end a point-to-point videoconference
1
Press the CONNECT/DISCONNECT (
Commander.
The message "Disconnect?" appears on the monitor screen.
2
Press the V or v button on the Remote Commander to select "OK", then
press the PUSH ENTER button, or press the CONNECT/DISCONNECT
(
To end a multipoint videoconference
Operations are the same as th.ose in Chapter 8, "Ending the Multipoint
Videoconference" on page 191.
208
/
) button again.
/
) button on the Remote