HP Designjet 3D Service Manual page 366

Hide thumbs Also See for Designjet 3D:

Table of Contents

25. Measure and record the diameter of circle D along the center line

26. Add the lengths derived from steps 24 and 25 (A-D and D-G) and then

27. Enter the Service Calibration menu by pressing the following button

28. Press the Edit Configuration button.

29. Press the GLeft button. Enter the value recorded from step

30. When finished, press Done...

Figure 336: Measuring distances from outside edges of D and G

between A and G. See

Figure 337: Measuring diameter of circle D

subtract the width of circle D derived from step 26. Record this total as

sequence on the display panel: 3,2,3,3,1. See

ing the Increment, Decrement and Next Digit buttons.

NOTE: The value for GLeft must be between 5.250" and 5.750".

Troubleshooting