Single Board Computer (Sbc); Removing The Single Board Computer - HP Designjet 3D Service Manual
Hide thumbs
Also See for Designjet 3D:
- User manual (30 pages) ,
- Assembly instructions manual (12 pages) ,
- Assembly instructions (5 pages)
Table of Contents
Advertisement
Single Board Computer (SBC)
Required Tools
Hardware
Removing the single board computer
1. Open the electronics bay. See
2. Touch the metal plate of the electronics bay cover to discharge any static
3. Remove the controller board. See
4. Disconnect the J2 power connector. See
5. Disconnect the SATA cable by pressing the tab in and pulling outwards.
Disconnect the J2
connector
-182
5
•
⁄
" nut driver or standard screwdriver.
16
•
Phillips screwdriver
1
•
6-32 x
⁄
" Phillips pan head screws (x4)
4
page 171
electricity.
page 179
See
Figure 92.
Figure 92: J2 power and SATA connector locations
"Opening the electronics bay" on
"Removing the controller board" on
Figure 92.
Disconnect SATA
connector
Advertisement
Table of Contents
Troubleshooting
