Chamber Thermocouple; Removing The Chamber Thermocouple; Installing The Chamber Thermocouple - HP Designjet 3D Service Manual
Hide thumbs
Also See for Designjet 3D:
- User manual (30 pages) ,
- Assembly instructions manual (12 pages) ,
- Assembly instructions (5 pages)
Table of Contents
Advertisement
Chamber Thermocouple
Required Tools
5
•
⁄
" nut driver.
16
•
standard screwdriver.
Removing the chamber thermocouple
1. Remove the top panel. See
2. Remove the side panels. See
3. Remove the upper electronics bay cover. See
tronics bay cover" on page 173
4. Remove the electronics bay. See
page 175
5. Push the strain relief clip out towards the front of the printer using a small
standard screwdriver. See
Figure 300: Strain relief clip location
Push the strain relief tab
towards the front of the
printer to remove.
6. Bend the tip of the thermocouple straight and slide out through the strain
relief clip.
7. Remove the thermocouple.
Installing the chamber thermocouple
1. Push the thermocouple through the mounting hole until it is 3/4" (19mm)
through the other side.
2. Push the strain relief in to lock the thermocouple in place.
3. Bend the thermocouple over to the left. See
"Removing the top panel" on page 161
"Removing the side panels" on page 162
"Removing the upper elec-
"Removing the electronics bay" on
Figure 300.
Figure 301.
-319
Advertisement
Table of Contents
Troubleshooting
