Consumable Parts And Cleaning Points; Removing The Stapler - Canon J1 Service Manual

Staple finisher / booklet finisher

Table of Contents

Parts Replacement and Cleaning Procedure > Consumable Parts and Cleaning Points > Removing the Stapler

Consumable Parts and Cleaning Points

NOTE:

When replacing the consumable parts, be sure to clear the parts counter.

(COPIER > COUNTER > DRBL-2 > FIN-STPR)

1) Remove the front

cover.(Refer to page 4-14)

2) Remove the front inside upper cover. (In the case of Staple Finisher, this procedure is

unnecessary.)(Refer to page 4-17)

3) Pull out the stapler, remove screw [1], and remove the PCB cover [2].

4) Release the claw [1] and remove the PCB [2].

5) Disconnect three connectors [3].

6) Remove screw [4] and remove the stapler together with the stapler base [5].

NOTE:

When removing, be careful not to damage the flag [6].

Parts Replacement and Cleaning Procedure > Consumable Parts and Cleaning Points > Removing the Stapler

7) Turn the stapler over, disconnect two connectors [1], remove two screws [2], and remove

F-4-63

the stapler from the stapler base.

4-31

F-4-64

F-4-65

4-31

Table of Contents

Show Quick Links

Table of Contents