Siemens SINUMERIK 840D Operator's Manual page 122
Handheld terminal
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
10
Machine Data, NC Start-Up, System Parameters – Operating Area Start-Up
10.2 Machine data
Motor controller The following softkeys are available:
10-122
Operating sequence
Select the machine data and activate the desired function with the
corresponding softkey:
Motor controller
Boot file
Further buttons
Drive -/+
Calculate
Calc. contr.
Boot file The following softkeys are available:
Del. boot file
Save boot file
Operating sequence
• Select or deselect via the SELECT key
• Press the OK softkey
The following safety prompt is then displayed:
Attention!
Calculating the controller data will stop the drives.
Any setting adjustments will be reset.
Press the OK softkey again to start the calculation.
New softkey bar is displayed
(See subsection: "Further buttons")
New softkey bar is displayed
(See subsection: "Further buttons")
Displays the previous/next drive
Calculate parameter(s)
Convert control paramaters (with safety
prompt: No, Yes)
Deletes the boot file
(with safety prompt: Cancel, Delete All, Yes)
Saves the boot file
(with safety prompt: Cancel, Save All, Yes)
SINUMERIK 840D/840Di/810D Operator's Guide Handheld Terminal 6 (BAH) - 03.04 Edition
10
03.04
Siemens AG, 2004. All rights reserved.
- Quick Links:
- Intended Use
Hide quick links:
Advertisement
Table of Contents
