1. Manuals
  2. Brands
  3. Hitachi Manuals
  4. Printer
  5. IJ UX
  6. Instruction manual

Hitachi IJ UX Instruction Manual page 245

Ink jet printer for industrial marking
Hide thumbs Also See for IJ UX:
Table of Contents

Advertisement

No.
Message
Ink Drop Charge
42
Too High
Barcode Short On
43
Numbers
44 Shutdown Fault
45 Count Overflow
Invalid Data
46
Change Timing
Invalid Count Data
47
Change Timing
Invalid Print Start
48
Timing
49 Print Overlap Fault
Print Head Cover
50
Open
Detector Position
51
Improper
Meaning of message
The charge sensor detects a high drop
charge.
The number of characters for the selected
barcode type is insufficient.
The shutdown process failed.
The calculation result of the count
multiplier overflowed.
A print operation was requested while the
print data was being changed.
A print operation was requested while the
print data was being changed.
The print target detection signal for the next
target arrived during the data was being
changed.
The print target detecter signal for the next
target arrived during the print operation for
the current target.
The print head cover is open.
The print target detecter signal turned OFF
before print start during printing at repeat
print setting.
Remedy
● Clean the gutter, deflection
electrode, and its
surroundings.
● Adjust the ink pressure.
(
Technical manual 6.9)
● Adjust the excitation V-ref. to
make sure that the ink drops
are well made.
(
Technical manual 6.10)
● Check that the ink stream is
correctly retracted.
● Please confirm the operation
of Circulation system.
(applied UX-E only)
(
Technical manual 6.15)
●Configure the number of
(
4.8.5) characters for
barcode to appropriate value.
(
Technical manual 9)
●Turn the printer power OFF by
main switch.
Contact your nearest local
distributor.
● Change the count multiplier
setting.
● Change of either data change
or print start.
● Change of either data change
or print start.
● Change of either data change
or print start.
● Increase the spacing between
products.
● If the target signal is
chattering, use sensor filter
setting. (
4.14.1).
● Remove the cover and then
hit the Clear key.
● If a magnetic substance is
used to fix the cover,
it must be replaced with
nonmagnetic resin (metal).
● Move the print target detecter
closer to the print head.
● If the target signal is
chattering, use sensor filter
setting.
● Check the data entered.
●On-screen message descriptions 9-8
Show Quick Links

Hide quick links:

Advertisement

Table of Contents
loading

Related Manuals for Hitachi IJ UX

Related Products for Hitachi IJ UX

Table of Contents