Huawei SmartAX MA5603T Configuration Manual page 381
Access module
Hide thumbs
Also See for SmartAX MA5603T:
- Hardware description (977 pages) ,
- Hardware description (65 pages)
Table of Contents
Advertisement
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
Issue 01 (2014-04-30)
7.
Confirm the service board.
Confirm the ASPB service board that carries services so that the board can work in
the normal state.
huawei(config)#board confirm 0/2
8.
Configure the PSTN user data.
Add POTS users (phones 0-31) so that the users can go online.
huawei(config)#esl user
huawei(config-esl-user)#mgpstnuser batadd 0/2/0 0/2/31 0
huawei(config-esl-user)#quit
9.
Save the data.
huawei(config)#save
Configure VAG2.
1.
Add the upstream VLAN interface.
According to the data plan, configure the secondary IP address of the Layer 3 interface
to 10.10.10.11, which facilitates the configuration of the media and signaling IP
address pools.
In step
Step
1, the VLAN is added and the IP address of the VLAN Layer 3 interface
is configured. In this step, use the sub parameter to configure the secondary IP address
of the VLAN. The secondary IP address is the same as the primary IP address in
function. They are used for Layer 3 forwarding.
huawei(config)#interface vlanif 20
huawei(config-if-vlanif20)#ip address 10.10.10.11 24 sub
huawei(config-if-vlanif20)#quit
2.
Configure the media and signaling IP address pools.
Add the IP address of the VLAN Layer 3 interface configured in the previous step to
the media and signaling IP address pools respectively. Therefore, the media and
signaling IP addresses used for the services can be selected from the IP address pools.
According to the data plan, IP address 10.10.10.11 is added to the media and signaling
IP address pools, and the gateway IP address corresponding to the media IP address
is 10.10.10.1.
huawei(config)#voip
huawei(config-voip)#ip address media 10.10.10.11 10.10.10.1
huawei(config-voip)#ip address signaling 10.10.10.11
huawei(config-voip)#quit
3.
Add an MG interface.
Add an MG interface for the MG to communicate with the MGC, which ensures that
the MGC can control the call connection through the MG interface. According to the
data plan, add MG interface 1, and configure the interface attributes.
huawei(config)#interface h248 1
Are you sure to add MG interface?(y/n)[n]:y
huawei(config-if-h248-1)#if-h248 attribute mg-media-ip1 10.10.10.11 mgip
10.10.10.11 mgport 2944 primary-mgc-ip1 10.10.20.20
primary-mgc-port 2944 code text transfer udp
4.
Configure the TID template of the PSTN users on MG interface 1.
Configure the TID generation mode. According to the data plan, the terminal prefix
of PSTN users is huawei, and the TID template adopts layering template 6.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
356
- Quick Links:
- Commissioning Introduction
Hide quick links:
Advertisement
Table of Contents
