Ani4 (For Selected Countries Only); Figure 3-148 Ani4 (For Selected Countries Only) - Interfaces - Siemens HiPath 5000 Service Manual

Hide thumbs Also See for HiPath 5000:

Table of Contents

Boards for HiPath 3000

ANI4 (for selected countries only)

Introduction

The ANI4 (Automatic Number Identification) board is responsible for receiving station numbers

modulated using the CPFSK method, demodulating them, and forwarding them to the base

system HiPath 3550 and HiPath 3350. In V4.0 SMR-7 or later, the station name is analyzed in

addition to the call number and shown on the telephone display.

Each ANI4 can serve four trunks. It contains the external trunk board hardware interfaces

(TMGL4) as well as a trunk and options bus interface. The trunks are transferred directly on the

board between the trunk and the trunk board interfaces.

Interfaces on the ANI4 module

*) Pins: Component side/solder side

Figure 3-148

ANI4 (for selected countries only) - Interfaces (S30807-Q6917-Axxx)

LED statuses and their meanings

On the ANI4 board two LEDs are implemented that show the status of trunk channel 1.

After system startup the green LED is on and the red LED is off. This signals that the layer-1

firmware has started correctly.

If ANI4 is recognized properly by the system, the green LED is reset (after all system software

initialization), and the bottom line of the display on the optiset E or optiPoint 500 phones ap-

pears. This means that the ANI4 has received system software activation for all four channels.

HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual

P31003-H3560-S403-54-7620, 09/05

Table of Contents

Hipath 3000 Hipath 3800