Table of Contents
Advertisement
In
Figure 6-1 "The Position of the Handset or Headset Connector."
connector is shown and in
MIC. 1
TEL. 1
1 2 3 4
Figure 6-4 Handset or Headset Connector
6.2.2.
Toggle mode
The telephone of the handset or headset is always switched on, on the right and the left side
connector. The microphone is switched on to either the left side or the right side. (In case of
'mute' no microphone is on.) To alternate the microphone from one side to another select the
soft key menu (by pressing the softkey) and execute the following steps:
1. Press the key which is under the notation 'Misc' on the display.
2. Press the key under the notation 'Hndset' on the display. Now the microphone is toggled.
On the display is denoted which side is selected.
6.3.
S
BUS CONNECTOR
0
Model 35 is connected to the ISPBX with a 2x2-wire twisted pair ISDN S
valid for model 25 if the S
J11 type.
Note: If your console is model 25, the Analogue Operator Interface connector must be covered
with a dummy plate (for safety reasons).
In
Figure 6-2 "Items at the Rear Side of Model 25."
in
Figure 6-5 "S0 Bus Interface Connector."
Figure 6-4 "Handset or Headset Connector"
MIC. 2
TEL. 2
bus interface is used. The connector on the Supervisor is a 6 pins
0
the pin layout.
the location of this
the location of this connector is shown and
the pin layout.
bus. This is also
0
49
- Quick Links:
- General
Hide quick links:
Advertisement
Table of Contents
