4.
MANAGEMENT TOOLS
4.1.
GENERAL
There are two management tools for the consoles which must be installed on a PC. The
communication between the console and the PC is by means of the V.24 port on the SV25 and
SV35.
4.1.1. Firmware Management Tool
The Firmware Management tool is used for uploading the firmware and language data.
Generally it will not be necessary to upload the firmware because it is stored in FEPROMs.
These FEPROMs keep their contents also during power failure. However, if the firmware or
languages for voice processing have to be upgraded or changed, it is necessary to load the
firmware (which also includes the voice processing languages). The firmware and the
languages are available on a service floppy together with the upload program.
4.1.2. Data Management Tool
The Data Management tool is used for uploading, downloading and editing of the following:
-
Directory data;
-
Status monitoring data;
-
Speed dialling keys data.
This program gives you the possibility to prepare a directory on the PC, or to download a
directory from the SuperVisor into the PC and to edit it. Afterwards you can restore it into
the supervisor. It is also possible to prepare and handle status monitoring data and data for the
speed dialling keys.
This tool can be used to retrieve and store directories for the SOPHO-SETs as well.
Note: Directory handling and speed dialling data handling is not possible for model 25. Handling
status monitoring data is only applicable for model 25 with S
Before using the PC, you have to connect the PC to the SuperVisor.
4.2.
CONNECTING THE PC
The PC has to be connected to the V.24/auxiliary interface at the rear side of the Supervisor.
This is a DCE interface on which only the Data-in and Data-out lines are used. No V.24
signalling is used on this interface!!
32
bus interface.
0