Table of Contents
Advertisement
Term
Line Hold Timeout
Liquid Crystal Display
(LCD)
Listen-in
Listen-in Module
Listen-In Only
Listen-in Time
Local Only
Local Programming
Location
Lockout
Log Event
Log Full
Logged into GSM
Network
Loop Response
Lost Clock Indication
Definition
A menu option that sets the length of time the CS534 listen-in module will remain
on the phone line with no activity from the central station. This time can be set
from 30 to 255 seconds. If it does not receive the digit within this time, the listen-in
module disconnects.
See Keypad display
A menu option that sends a report to the central station indicating that a listen-in
session must be started.
Listen-in is a user function. In order to use listen-in, a CS534 listen-in module must
be installed and a microphone must be connected. When an alarm is generated
and reported, the central station can listen to what is happening on the premises.
Certain protocols (such as SIA, Contact ID and 200Bd FSK) have 'listen-in blocks'
that are communicated with the alarm code and indicate that a listen-in session
must be started.
See CS534 Listen-in Module
A menu option that enables the listen-in only mode. This is the mode in which the
central station can monitor sounds at the customer's premises but cannot
establish two-way communication.
See High Gain Listen In and Low Gain Listen In
A menu option that sets the length of time the central station can listen for sounds
of intrusion by means of microphones at the alarm site.
A zone characteristic that causes that zone not to report alarms to the central
station. Locally, the sirens are activated according to the other zone type
characteristics.
A menu option that disables the installer menu. This option can be set only
through the up/download software.
A programmable unit of a module. Different options can be specified for each
location. Each location contains one or more segments. Locations are
programmed on the CS5500 menu keypad using menu options.
A menu entry that groups options that lock certain system functions.
See also System Shutdown, Local Programming, Comms Settings and Download
Settings
A menu option that causes the selected output to log an event when it is activated.
This is available only on the CS507 output expander module. (Outputs)
A menu option that enables log event transition broadcasts. (Transition
Broadcasts)
A menu option that causes the control panel to log an event each time an output
on the CS507 output expander module trips and each time an output restores.
(Commands/Requests)
A menu option that sends a report to the central station when the event log is full.
(System Reports)
A menu entry that groups the report codes sent to the central station when the
event log is full. (Report Codes)
A menu option that indicates that the CS7001 GSM module is logged into the
GSM network.
A zone characteristic of on-board control panel zones that specifies the response
rate. This can be either 500 ms or 50 ms.
A menu option that enables the service message 'Control Loss of time'. See
appendix 5 in the CS5500 Programming Manual for a list of all service messages.
Hide quick links:
Advertisement
Table of Contents
