Table of Contents
Advertisement
Term
Batt Dynamic Test
Duration
Batt Presence Test
Battery Test
Battery Test Time
Baud rate
Beep on Panics
Beep on RF Lost
Bit Error Rate
Blank Keypads
Blind dialling
Box Tamper
Box Trouble
Broadcast X10 Function A menu option that causes the CS1700 proximity reader to transmit an X-10
Burglary alarm
Burglary zone
Bus
Bus Comm Error
Buzzer
Buzzer Follows Keypad A menu option that makes the reader buzzer settings the same as the keypad
Bypass
Bypass on Force Arm
Bypass Toggle
Bypass Zones
Bypassable
Definition
A menu option that sets the length of time that the control panel performs the
Dynamic Battery test. This can be between 0 to 255 minutes where 0 is no test.
A menu option that enables a test to determine whether the battery is connected
to the system. This test is usually performed automatically when the system is first
powered up and periodically thereafter.
See Batt Presence Test
See Batt Dynamic Test Duration
A data communications speed used on a serial port. For example, 2400 Baud,
4800 Baud, 9600 Baud, 19200 Baud, 38400 Baud.
A menu option that sounds a keypad beep when the personal attack alarm
combination keys are held down long enough.
A menu option that activates the keypad sounder, causing it to beep, when an RF
zone is lost. This beep indicates that the receiver did not receive the supervision
signal from the wireless transmitter.
A menu option that specifies the Bit Error Rate reading in GSM module modem
applications. The BER is set at nine if unknown. This information is used for
verification purposes only.
A menu option that allows an authorised user to turn off all LEDs (except the
Power LED) on the keypad and to lock the keypad so that it does not accept key
presses.
A mode in which the control panel does not wait for a dial tone before dialling the
phone number. Blind dialling is enabled by programming a four second delay (#3)
as the first digit in Phone Prefix. It is used when the phone system has a poor
quality dial tone or does not generate a dial tone.
See also Phone Prefix
A menu option that sends a report if the box tamper is detected. (System Reports)
A menu option that enables the box tamper switch on the control panel. The
CSx75 has an input for a normally closed tamper switch. When opened, a box
tamper is reported as an event. (System Settings)
A menu option that enables the box tamper switch on the selected RF receiver.
(RF Receivers)
See also Case Tamper
A menu entry that groups the report codes sent to the central station when a Box
Trouble condition is activated. (Report Codes)
See also Case Tamper
function to the home automation system.
An alarm that occurs when the system is armed and a burglary zone is activated.
An event can be programmed to report to the central station.
A zone type that generates an alarm if it is activated when armed. A forced arm
can exclude a burglary zone.
A method of connecting devices together. Every device is connected to the same
set of wires and has a unique address.
A menu option that sets the SIA character, the partition and user number that are
sent by the GSM module when Bus communication problems occur.
A local low volume vibrating audio output, typically located in the keypad.
buzzer settings. This is a CS1700 proximity reader option.
To temporarily remove a zone from operation when arming the system.
A menu option that enables bypass reporting when a zone is force armed.
A menu option that allows an interior zone be bypassed or included while the
system is armed.
A menu option that allows the selected code to bypass zones.
A zone characteristic that allows the zone to be bypassed.
Hide quick links:
Advertisement
Table of Contents
