Table of Contents
Advertisement
1.6 Mode Feature
Main Stack Mode : Must be able to receive faced-down images from the IOT and stack as much as
3,000 sheets (A4/LT 80gsm) onto the main stacker tray. The Stacker tray must be able to
accommodate various types and sizes of sheets.
Offset Mode : Shifts the space between sets to 30mm in order to distinguish sets that have been
post-processed during Main Stack Mode.
Top Stack Mode : The finisher must be able to assort and discharge papers to the top tray, and
stack as much as 250 sheets(80gsm). Sheets that have been collected to the Top tray cannot access
post-processing functions such as offset, stapling, punching, etc.
Staple Mode : When the user selects this mode, it staples designated corner of the papers that have
to compiled (more than 2 pages).
. Corner staple(Front, Rear): Clinches at 45 degrees from the paper path.
. Dual staple: Clinches at 90 degree from the paper path designated according to the type of paper
In case of simplex copy, the clincher leg must face the back side of the image. The stapler must be
able to clinch as much as 50 sheets (90gsm).
Hole Punch : The punch module should accommodate NA2/3, EU2/4, or Scandinavia 4 hole
module(TBD) depending on the target market. There must be a waste hopper that collects wastes
produced during hole punching. The waste hopper must be big enough to allow at least 5,000
punches before it becomes full.
Booklet Maker Mode : A Dual Stapling must be possible at V-folding line of the paper (that can
cover 15 sheets, or a 216gsm cover + fourteen 80gsm sheets, etc) that goes through the Booklet
maker. The folding is positioned at the centerline of the paper path.
Service Manual
CLX-FIN40S/CLX-FIN40L
1. Specification
1-10
SAMSUNG ELECTRONICS
Hide quick links:
Advertisement
Table of Contents
