Table of Contents
Advertisement
● Code : H2-3007
● Symptom :
At warm up, the paper is detected in the booklet maker folder.
● Troubleshooting method :
Check if there is any paper on the booklet-maker folding area. Remove it if there is.
If the error still occurs, check the followings.
Is the booklet maker folding exit sensor working? (Perform diagnostic routine 116-5580)
YES / NO
1. Check if the sensor actuator is out-of-place.
2. Check if the connector of the sensor is disconnected.
3. Check if the connector J6 on the booklet maker main board is disconnected.
4. Check the harness continuity and replace it if required.
5. Replace the booklet maker folding exit sensor.
6. Replace the booklet maker main control board.
Power off then on.
Service Manual
CLX-FIN40S/CLX-FIN40L
4. Troubleshooting
● Error message : Paper jam before booklet folding
4-28
SAMSUNG ELECTRONICS
Hide quick links:
Advertisement
Table of Contents
