Table of Contents
Advertisement
Mounting the RP2 to a wall, swing arm, or pole-mounted
bracket
The RP2 can be attached to a wall, swing arm, pole-mounted bracket, or other mounting fixture. This
RP2 supports the VESA industry standard 100 mm spacing between mounting holes.
NOTE:
There are two sets of VESA industry standard screw holes on the rear: a 75 mm x 75 mm
pattern (1) and a 100 mm x 100 mm pattern (2). The stand attaches to the 75 mm x 75 mm pattern.
The 100 mm x 100 mm pattern can be used to attach a mounting device, such as the HP Quick
Release.
This apparatus is intended to be supported by UL or CSA Listed wall mount bracket. HP recommends
that you use an HP Quick Release mounting bracket for wall mounting (part number EM870AA).
CAUTION:
long screws are required. Longer screws must not be used because they may damage the system. It
is important to verify that the manufacturer's mounting solution is compliant with the VESA standard
and is rated to support the weight of the system.
6
Chapter 2 Hardware upgrades
To attach a third-party mounting solution to the RP2, four 4 mm, 0.7 pitch, and 10 mm
- Quick Links:
- Removing the Front Panel
Hide quick links:
Advertisement
Table of Contents
