Regulating The Flame; Switching Off - Miele CS 1013-1 Operating And Installation Instructions
Hide thumbs
Also See for CS 1013-1:
- Operating and installation instructions (60 pages) ,
- Operating and installation instructions (52 pages) ,
- Operating and installation instructions (52 pages)
Table of Contents
Advertisement
Operation
Switching on
^ The control for the burner required
must be pressed in and turned
anti-clockwise to the large flame
symbol to switch on.
^ When the flame ignites, keep the
control pressed in for 8-10 seconds,
and then let it go.
Do not press the control knob for
more than 15 seconds. If the burner
does not ignite within these 15
seconds, release the control knob
and open the door or wait for at least
1 minute before making a new
ignition attempt.
In the event of the burner flames being
accidentally extinguished, turn off the
burner control and do not attempt to
re-ignite the burner for at least 1 min.
In the event of a power cut
If there is an interruption to the
electricity supply the gas can be
ignited with a match:
^ Press in the relevant control and turn
it anti-clockwise to the large gas
symbol.
^ Hold the control pressed in and light
the gas at the burner with a match.
16
^ Keep the control pressed in for a
further 8-10 seconds and then
release it.
Regulating the flame
The burners can be regulated at any
level between the strongest and
weakest flame.
Control the flame so that it does not
spread out beyond the sides of the
pan. As the outer part of the flame is
much hotter than the centre, the tips of
the flames should stay beneath the pan
base. Flame tips which extend beyond
the sides of the pan merely warm up
the air in the room and can also
damage pan handles and increase the
risk of injury.
Switching off
^ Turn the control clockwise to position
"ß" .
This stops the flow of gas and the flame
goes out.
Advertisement
Table of Contents
