Table of Contents
Advertisement
Switching on
^ The control for the burner must be
pressed in and turned anti-clockwise
to the ignition position a to switch
on.
^ When the flame ignites, keep the
control pressed in for 8-10 seconds,
and then let it go.
If the flame goes out, repeat the
procedure, keeping the control pressed
in for a few extra seconds.
In the event of a power cut
If there is an interruption to the
electricity supply the gas can be
ignited with a match:
^ Press in the relevant control and turn
it anti-clockwise to the large gas
symbol.
^ Hold the control pressed in and light
the gas at the burner with a match.
^ Keep the control pressed in for a
further 8-10 seconds and then
release it.
Regulating the flame
Control the flame so that it does not
spread out beyond the sides of the
pan. As the outer part of the flame is
much hotter than the centre, the tips of
the flames should stay beneath the pan
base. Flame tips which extend beyond
the sides of the pan merely warm up
the air in the room and can also
damage pan handles and increase the
risk of injury.
There is a resistance at the 6 o'clock
position to prevent you turning the
control to the high or low setting
unintentionally. To move from the high
to the low setting, you need to press the
control down to be able to pass the 6
o'clock position.
^ To move from the high to the low
setting, turn the control anti-
clockwise until it meets a resistance.
Then press it down and continue to
turn it past the resistance before
releasing it. You can now select the
setting you require.
^ To move from the low to the high
setting, turn the control clockwise
until it meets a resistance. Then
press it down and continue to turn it
past the resistance before releasing
it. You can now select the setting you
require.
Switching off
^ Turn the control clockwise to position
ß b.
This stops the flow of gas and the flame
goes out.
Operation
23
- Quick Links:
- Burner
- Safety Instructions for Installation
Hide quick links:
Advertisement
Table of Contents
