Table of Contents
Advertisement
Memo
● If configuring a small network consisting of only your
machine and a computer, set IP addresses as shown
below (according to RFC1918).
For the computer
IP address :
192.168.0.1~254
Subnet mask :
255.255.255.0
Default gateway :
not used
DNS server :
not used
For the machine
IP Address Set :
Manual
IPv4 Address :
192.168.0.1~254
(select a different value
from the computer)
Subnet Mask :
255.255.255.0
Gateway Address :
0.0.0.0
Network Scale :
Small
● To set [Network Scale], press the <SETTING> key
and then select [Admin Setup] > [Network Menu] >
[Network Setup] > [Network Scale].
1
Prepare an Ethernet cable and a hub.
Prepare an Ethernet cable (category 5, twisted
pair, straight) and a hub separately.
2
Hold down the power switch for
approximately one second to turn off the
power.
3
Plug one end of the Ethernet cable into
the network interface connection on the
back of the machine.
4
Plug the other end of the Ethernet cable
into the hub.
5
Hold down the power switch for
approximately one second to turn on the
power.
- 85 -
Scanning to Local PC
4
- Quick Links:
- Machine Setup
- Installing Your Machine
Hide quick links:
Advertisement
Table of Contents
