Loading Paper into the Large Capacity Tray
This section describes how to load paper into the LCT.
• The LCT is identified as Tray 4, Tray 5, and Tray 6.
• Various sizes of paper can be loaded in Tray 4 and Tray 5 by adjusting the positions of side fence
and end fence.
1
• Tray 6 uses 8
/
× 11 paper. If you want to load A5
2
your service representative.
• Check the paper edges are aligned at the left side.
• Do not stack paper over the limit mark.
• When setting tab stock, always use the tab sheet holder.
• Tab stock can be loaded only in Tray 4 and Tray 5.
1.
Carefully pull out the paper tray until it stops.
2.
Load paper into the paper tray by pushing it against to the left side of the paper tray.
Load the paper print side up.
, B5 JIS , A4 , 5
BJU117S
BQX053S
Loading Paper
1
1
/
× 8
/
, contact
2
2
3
89