Computer Setup-Power; Computer Setup-Advanced - HP t620 Troubleshooting Manual
Flexible series thin client
Hide thumbs
Also See for t620:
- Quick setup manual (73 pages) ,
- Hardware reference manual (53 pages) ,
- Quick installation manual (4 pages)
Table of Contents
Advertisement
Computer Setup—Power
NOTE:
Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table A-2
Option
Hardware Power
Management
Thermal
Computer Setup—Advanced
NOTE:
Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table A-3
Option
Power-On Options
BIOS Power-On
Onboard Devices
38
Appendix A Computer Setup (F10) Utility, BIOS Settings
Computer Setup—Power
Description
SATA Power Management – Enables or disables SATA bus and/or device power management.
Default is enabled.
S5 Maximum Power Savings – Turns off power to all nonessential hardware when system is off to
meet EUP Lot 6 requirement of less than 0.5 Watt power usage. Default is disabled.
S4/S5 Wake on LAN (Disable/Enable). Permits the user to control whether the system should wake
from S4 of S5 if a magic packet id received by NIC.
CPU Fan speed (Read-Only), show the CPU fan speed in RPM on the t620 Flex system.
Computer Setup—Advanced (for advanced users)
Heading
Allows you to set:
POST messages (enable/disable). Default is disabled.
After Power Loss (off/on/previous state). Default is Power off. Setting this option to:
Power off—causes the computer to remain powered off when power is restored.
Power on—causes the computer to power on automatically as soon as power is restored.
Previous state—causes the computer to power on automatically as soon as power is
restored, if it was on when power was lost.
NOTE:
If you turn off power to the computer using the switch on a power strip, you will not be
able to use the suspend/sleep feature or the Remote Management features.
POST Delay (in seconds). Enabling this feature will add a user-specified delay to the POST
process. This delay is sometimes needed for hard disks on some PCI cards that spin up very
slowly, so slowly that they are not ready to boot by the time POST is finished. The POST delay
also gives you more time to select
Allows you to set the computer to turn on automatically at a time you specify.
Allows you to set resources for or disable Legacy devices.
F10
to enter Computer (F10) Setup. Default is None.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
