Removing And Replacing The Battery - HP t620 Troubleshooting Manual
Flexible series thin client
Hide thumbs
Also See for t620:
- Quick setup manual (73 pages) ,
- Hardware reference manual (53 pages) ,
- Quick installation manual (4 pages)
Table of Contents
Advertisement
Removing and replacing the battery
WARNING!
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1.
Remove/disengage any security devices that prohibit opening the computer.
2.
Remove all removable media, such as USB flash drives, from the computer.
3.
Turn off the computer properly through the operating system, and then turn off any external
devices.
4.
Disconnect the power cord from the power outlet, and disconnect any external devices.
CAUTION:
long as the system is plugged into an active AC outlet. You must disconnect the power cord to
avoid damage to the internal components of the computer.
5.
Remove the computer from the stand and lay the computer down with the right side up.
6.
Remove the computer access panel and back I/O panel. See
panel on page
7.
If the computer is an HP t620 PLUS Thin Client, perform the following steps:
a.
Push the fan assembly latch (1) toward the front of the computer and rotate the assembly (2)
up and out of the way.
b.
If a PCIe card is installed, remove it carefully.
28
Chapter 2 Hardware changes
Before removing the side access panel, be sure that the thin client is turned off and the
Regardless of the power-on state, voltage is always present on the system board as
8.
Removing and replacing the access
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
