Yamaha YSP-3000 Service Manual page 41
Hide thumbs
Also See for YSP-3000:
- Owner's manual (663 pages) ,
- Reference manual (12 pages) ,
- New product bulletin (2 pages)
Table of Contents
Advertisement
6. MANUAL TEST
The noise generator with a built-in DSP outputs the
test noise through the channels specified by the sub-
menu.
The noise frequency is 30 to 80Hz for LFE but 500 to
2kHz for others.
TEST ALL
6.TEST ALL
Noise is output from all channels.
TEST FRONT R
6.TEST FRNT R
Noise is output from the FRONT R channel.
TEST LFE
6.TEST
LFE
Noise is output from the SUBWOOFER channel.
7. RS-232C
Not applied to these models.
TxD/RxD DATA
HARD FLOW
8. FACTORY PRESET
This menu is used to reserve and inhibit initialization of
the back-up RAM.
8. PRESET INHI
8. PRESET RSRV
TEST FRONT L
6.TEST FRNT L
Noise is output from the FRONT L channel.
TEST SURROUND R
6.TEST SURR R
Noise is output from the SURROUND R channel.
7. TxRxData:NG
7. HardFlow:NG
PRESET INHIBIT (Initialization inhibited) /
RAM initialization is not executed. Select this sub-menu to protect the values set by the
user.
PRESET RESERVED (Initialization reserved) /
Initialization of the back-up RAM is reserved. (Actually, initialization is executed the next
time that the power is turned on.) Select this sub-menu to reset to the original factory
settings or to reset the RAM. Any protection history will be cleared.
YSP-3000/YSP-30D/HTY-7030
TEST CENTER
6.TEST CENTER
Noise is output from the CENTER channel.
TEST SURROUND L
6.TEST SURR L
Noise is output from the SURROUND L channel.
41
Hide quick links:
Advertisement
Table of Contents
