Yamaha YSP-3000 Service Manual page 21
Hide thumbs
Also See for YSP-3000:
- Owner's manual (663 pages) ,
- Reference manual (12 pages) ,
- New product bulletin (2 pages)
Table of Contents
Advertisement
4. Select the self-diagnostic function menu "19-2. checksum".
Check the displayed checksum is the same as the writ-
ten firmware checksum.
* When the displayed firmware version and checksum
are different from written firmware version and
checksum, follow the steps from 1 to 9 of "Writing to
the microprocessor" again.
• Initializing of the main unit
* After updating the firmware, be sure to initialize the
main unit.
1. Connect the power cable of main unit to the AC outlet.
2. While pressing the "VOL+" key and "VOL-" key of the
main unit, press the "STANDBY/ON" key of the remote
control to activate the self-diagnostic function.
Then the self-diagnostic function is activated.
3. Select the self-diagnostic function menu "8. FACTORY
PRESET".
4. Select the "PRESET RSRV".
PRESET INHIBIT (Initialization inhibited) /
8. PRESET INHI
5. Turn off the power of main unit and disconnect the
power cable from the AC outlet.
Writing to the DSP1
1. Before turning on the power to main unit and PC, con-
nect each of them using RS232C conversion jig and
RS232C cable (cross cable). (Fig. 1)
2. Start up DSP_FLASHER(YSP).exe, the screen will
appear as shown below.
CHECK SUM:FAAF
YSP-3000/YSP-30D/HTY-7030
PRESET RESERVED (Initialization reserved) /
8. PRESET RSRV
21
Hide quick links:
Advertisement
Table of Contents
