System Installation And Configuration; Plan The Installation - Bosch ICP-EZM2 Easy Series System Reference Manual
Easy series
Hide thumbs
Also See for ICP-EZM2 Easy Series:
- Installer's manual (80 pages) ,
- System reference manual (118 pages) ,
- Quick start manual (24 pages)
Table of Contents
Advertisement
12
en | System Installation and Configuration
2
System Installation and Configuration
2.1
Plan the Installation
When planning the installation, identify suitable locations for the control panel, control
center, hub, and wireless devices before installing any system components. When identifying
these locations, ensure that the following considerations are addressed.
Task
1. Identify the location for
the control panel.
2. Test for GSM signal
strength.
3. Identify the location for
the control center.
4. Identify the location for
the wLSN Hub.
5. Identify the location for
the wLSN devices.
Table 2.1 Installation Considerations
F01U087835 | 02 | 2008.10
Considerations
–
Only use authorized service personnel to install this system.
–
Plan to install the control panel in a centrally located room that is near the AC
Power MAINS.
–
Plan to install the control panel in a location with a good earth ground.
–
Because the control panel is permanently connected equipment, a readily
accessible disconnect device must be included into the building installation
wiring.
Use your cell phone to identify an area with good GSM signal strength by monitoring
the signal strength on your mobile phone.
If the intended location of the control panel has poor GSM signal strength, find a
new location for the control panel.
Plan to install the control center near the primary entry and exit door.
Plan to install the wLSN Hub in a location with good radio-frequency (RF)
characteristics and within 100 m of the control panel.
–
wLSN devices are intended only for indoor, dry applications. Avoid installing the
devices where excessive humidity or moisture, or temperatures outside of the
acceptable operating range, exist.
–
Mount wLSN devices on flat, rigid surfaces. For more information, refer to each
device's installation instructions.
–
Avoid mounting wLSN devices in areas with large metallic objects, electrical
panels or electric motors. They might reduce the (RF) range of a wLSN device.
System Reference Guide
Easy Series
Bosch Security Systems, Inc.
Advertisement
Table of Contents
