Table of Contents
Advertisement
2. Installation
2. I Accessories Checking
Prior to installation. please make sure all accessories are available. Contact your producl
dealer immediately if any accessories are missing or damaged.
Item
309
609
I
Screw for camera mountinq
I (if camera is not included; suitable for most
commonly used zoom cameras)
2
Cotton Gloves
I pair
J
User's manual for camera
I (if camera is provided)
4
User's manual for pan/tilt
For the convenience of RMA service. please store all original packing materials properly.
2.2 Dipswitch Setup
Before installation, correctly set up dome address. protocol, and baud rate. Dome address,
protocol and baud rate can be set up through adjusting dipswitches on the dome drive.
2.2.1- Dome Address Setup
Dipswitches I to 6 are for dome address setting. Dome address can be set to any number
from 0 to 64. Refer to the following chart in Appendix I for corresponding address and dipswitch
positions. Default is l.
2-2.2. Protocol and Baud Rate Setup
Dipswitches 7 to l0 are for protocol setting; I I and 12 are for baud rate. Refer to the
following two tables for the positioning of dipswitches and the corresponding protocols and baud
rate. Default protocol and baud rate are Pelco D. 2400. Because the camera provided supports
Pelco D (2400) protocol only, please keep the default setting for the protocol and baud rate.
Dipswitch
Positions
Baud rate
Dipswitch
Positions
Baud rate
H
1200
H
4800
E
2400
E
9600
Advertisement
Table of Contents
