Configuring The Ip Address For An Interface - HP A-F5000 Installation Manual
Hide thumbs
Also See for A-F5000:
- Product end-of-life disassembly instructions (4 pages) ,
- Getting started manual (145 pages)
Table of Contents
Advertisement
Item
HTTPS
Configuring the IP address for an interface
Click Next on the service management configuration page to enter the interface IP address configuration
page, as shown in
Ethernet interfaces and VLAN interfaces. You can click a value in the table and then modify it. Only when
the IP configuration is Static Address, you can configure the IP address and mask.
Figure 42 Basic configuration wizard: 4/6 (interface IP configuration)
Description
Specify whether to enable HTTPS on the device, and set the HTTPS port number.
HTTPS is the HTTP protocol that supports the Secure Sockets Layer (SSL) protocol. It
can improve device security. For more information about HTTPS.
Disabled by default.
IMPORTANT:
•
If the current user logged in to the web interface through HTTPS, disabling HTTPS
or modifying the HTTPS port number will result in disconnection with the device;
therefore, perform the operation with caution.
•
When you modify a port number, ensure that the port number is not used by
another service.
•
By default, HTTPS uses the PKI domain default. If this PKI domain does not exist, the
system will prompt you for it when the configuration wizard is completed; however,
this will not affect the execution of other configurations.
Figure
42. The table lists the IP address configuration information for all Layer 3
39
Advertisement
Table of Contents
