Table of Contents
Advertisement
Printer Cabling and Interfacing:
When the Printer receives data from any host system, it will not
properly function with an incorrectly wired cable. Proper wiring
diagrams can be found in Appendix E. Table B-1 contains a list of the
signals that if correctly wired to the host system will cause the Printer
to operate properly.
When the Printer is turned on, it will default to pre-determined
interfacing parameters. The default values are in Table B-2.
Table B-2 Printer Default Communication Parameters
Altering the switch positions of Dip Switch S1 on the back of the
Printer will configure the Printer for different applications. Chapter 2,
Section 2.4 shows the switch positions and the configurations
supported by each setting.
B-2
Switch Settings and Cable Interfacing
Signal
TX
RX
BUSY
Ground
Jumper
Shield
Table B-1 I/O Port Wiring
Parameter
Default Value
BAUD
9600
Data Bits
8
Parity
None
Stop Bits
1
Pin
2
3
20
7
4 to 5
1
DMX400/430 Operator's Manual
Advertisement
Table of Contents
Troubleshooting
