Removing The Carriage ,Y Axis. Motor - HP 200 Service Manual
Hp all in one printer user manual
Hide thumbs
Also See for 200:
- User manual (2 pages) ,
- Update manual (9 pages) ,
- Configuration manual (40 pages)
Table of Contents
Advertisement
Removing the Carriage ,Y Axis. Motor
1 Remove the electronics enclosure
cover D page 6 5.
2 Remove the window D page 6 15.
3 Remove the center cover D page 6 16.
4 Remove the right endcover D page 6 19.
6 Pressing the small drive belt against the
tensioner wheel in the belt tensioner to
loosen the belt, slide the belt off of the
motor gear; then carefully release your
hand from the the tensioner wheel.
Tensioner wheel
Motor gear
Small drive belt
0D2 DmbtinJ: En
e ha he bel i
c
ec ly
i i ned a
ca iage m
gea and he l we
he d
ble
lley
C3187 90000
5 Disconnect the carriage motor cable from
the main PCA (connector labelled Y), and
from the lowest ferrite holder on the
right hand side of the plotter.
7 Loosen the two carriage motor screws
about 1/2 cm (about 1/4 inch).
Double pulley
1
2
nd he
a
f
Carriage-motor
connector
Torx-15
Loosen
Removal and Replacement
6 35
- Quick Links:
- Part Numbers
- Product Information
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
