Removing The Trailing Cable Guide - HP 200 Service Manual
Hp all in one printer user manual
Hide thumbs
Also See for 200:
- User manual (2 pages) ,
- Update manual (9 pages) ,
- Configuration manual (40 pages)
Table of Contents
Advertisement
Removing the Trailing Cable Guide
C A U T I O N
Handle the trailing cable and the
trailing cable guide with care.
1 Remove the window D page 6 15.
2 Remove the center cover D page 6 16.
3 Remove the left endcover D page 6 18.
4 Remove the right endcover D page 6 19.
5 If the maintenance you need to perform
requires you to remove the trailing cable
as well as the trailing cable guide, then
remove the trailing cable now D page 6 29.
C A U T I O N
Exercise care to avoid damaging the ferrite
ring when carrying out the following
instructions.
7 Cut the plastic tie, on the spring in the
ferrite ring, located where the trailing
cable guide attaches to the Y drive
bracket.
Ferrite ring
0D2 DmbtinJ: Attach a new plastic tie
C3187 90000
6 Remove the screw that attaches the
trailing cable guide to the tensioner
housing.
Trailing-cable guide
8 Using a screwdriver, compress and
release the spring from between the
inside surface of the ferrite ring and the
trailing cable guide.
Trailing-cable
guide
Spring
and tie
Torx-15
Tensioner
housing
Removal and Replacement
6 43
- Quick Links:
- Part Numbers
- Product Information
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
