Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 4-14 List of Default Values That Can Be Set Using IP Information and Default
Information
Group Name
IP interface
information
ARP
information
DHCP
information
4-52
Values During Initial Installation
Information Name
ARP cache table aging time
Interface type (Valid only for ATM/
Frame-Relay.)
Proxy ARP response
Encapsulation format of ARP request
frame (Hardware type)
Maximum number of transmission retries
in ARP request frame
Transmission retry interval of ARP request
frame
Relay of IP packets with source route
option
ICMP redirect message transmission
switch
ICMPv6 redirect message transmission
switch
Direct broadcast relay switch
Subnet broadcast relay switch
Non-response option of ICMPv6 node
information query
rate limiting option (RFC2463)
ARP hardware type
Hops threshold value
Initial Value
30 minutes
Broad-type
No proxy ARP response is made.
ethernet
4 times
2 seconds
IP packets with a source router option are
relayed.
Transmit
Transmit
Not relayed.
Not relayed.
•
The initial value responds.
ip_icmp6_nodeinfo_query
•
To set a non-response option, execute
the following.
ip_icmp6_nodeinfo_query_off
•
The transmission rate of an ICMPv6
error is limited to 1 packet/
<Microsecond> (maximum).
•
The initial value is enabled(500 s).
•
To disable this function, set the
<Microsecond> value to "0".
•
The <Microsecond> value can be set
up to 1000 in units of 0 to 10.
Ethernet
4
GR2K-GA-0014
Ver. 07-02